Hello i’m new and idk what’s going on :-(
The first layer doesn't adhere to the hotbed and ends up detaching. Additionally, I think I noticed that the filament didn't even come out of the nozzle, it seemed to be suspended in mid-air as if it had cooled down too quickly. I've also observed that when printing starts, the fan is at 0% by default. This is like the tenth time I've printed and I hadn't had any issues until now. I'm using 200°C nozzle temperature, 60°C bed temperature, SUNLU filament, and Cura software
The first layer doesn't adhere to the hotbed and ends up detaching. Additionally, I think I noticed that the filament didn't even come out of the nozzle, it seemed to be suspended in mid-air as if it had cooled down too quickly. I've also observed that when printing starts, the fan is at 0% by default. This is like the tenth time I've printed and I hadn't had any issues until now. I'm using 200°C nozzle temperature, 60°C bed temperature, SUNLU filament, and Cura software